EF Logo

J1939 · Sensors

SPN 91 FMI 3

Accelerator pedal sensor 1 voltage high

What does SPN 91 FMI 3 mean?

The accelerator pedal sensor 1 signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: with the key on, watch the accelerator pedal sensor 1 live; if it sits at maximum at once the fault is solid rather than intermittent.

FaultCheckSPN 91FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

With the key on, watch the accelerator pedal sensor 1 live; if it sits at maximum at once the fault is solid rather than intermittent

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal pin backed out or broken in the accelerator pedal sensor 1 connector, leaving the ECM input unconnected
  • Ground lost at the accelerator pedal sensor 1, or the signal shorted to a supply wire in the same harness run
  • Pedal plug pushed back or crushed by a floor mat or boot, leaving the signal open
  • Signal wire damaged where it passes the firewall grommet or pedal bracket and touching a supply wire
1 more cause
  • Pedal assembly worn or fitted with a unit that was never learned, reading full scale at rest

How it failed

You'll notice: Throttle response is wrong: the pedal may do nothing, the engine may sit at a fixed idle or limp-home speed, or it may rev without pedal input, and the check-engine lamp comes on.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 91 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.