EF Logo

Bobcat · Engine

Bobcat Fault Code M0613

Engine speed no signal

What does Bobcat code M0613 mean?

The controller is not getting a speed pulse from the engine. The machine may crank but not start, or stall. Urgency: check soon - the machine may derate or limit a function. Check first: unplug the sensor and check the plug for pushed-back pins or corrosion before testing anything else.

FaultCheckM0613Bobcat · Engine

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Unplug the sensor and check the plug for pushed-back pins or corrosion before testing anything else

Then 3 more checks
Code shows hereFAULTM0613

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 4 done

Causes

  • Wrong air gap or damaged tone wheel
  • Failed speed sensor
  • Debris or metal on the sensor tip
  • Broken wire or loose pin in the sensor plug

How it failed

You'll notice: No engine speed signal reaches the controller.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine speed, ECU messages and power derate

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M0613 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders S450-S850 and T450-T870.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.