EF Logo

Bobcat · Fuel system

Bobcat Fault Code 14‑03

Fuel shut-off pull solenoid error OFF

What does Bobcat code 14-03 mean?

The fuel pull solenoid is not energised when it should be on, so the engine may not start. Urgency: stop now - shut down and fix before working on. Check first: check the wiring along the engine harness around the shut-off plug where heat and vibration crack the insulation for continuity and for pins pushed back out of their housings.

FaultStop14-03Bobcat · Fuel system

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check the wiring along the engine harness around the shut-off plug where heat and vibration crack the insulation for continuity and for pins pushed back out of their housings

Then 5 more checks
Code shows hereFAULT14-03

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 6 done

Causes

  • Output driver not switching
  • Broken wire or loose plug
  • Blown fuse on the fuel pull solenoid feed
  • Open coil
1 more cause
  • Vibration fatigue in the wires at the shut-off plug

How it failed

You'll notice: The controller sees the fuel pull solenoid not energised when it has asked for it.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Make the machine safe before you start: on firm level ground, attachments down, key out.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Fuel hold, fuel pull and lift pump circuits

Source

Bobcat S205 Operation & Maintenance Manual, service codes list

This source lists 14-03 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Older Bobcat skid-steer and track loaders using the two-digit service codes (S205 manual, similar models).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.