EF Logo

Bobcat · Fuel system

Bobcat Fault Code M1403

Fuel pull output error off

What does Bobcat code M1403 mean?

The controller sees the fuel pull solenoid not energised when it is commanded on. The engine will not start if the pull coil is not working. Urgency: stop now - shut down and fix before working on. Check first: inspect the engine harness around the shut-off plug where heat and vibration crack the insulation for breaks, rubbing and corrosion.

FaultStopM1403Bobcat · Fuel system

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Inspect the engine harness around the shut-off plug where heat and vibration crack the insulation for breaks, rubbing and corrosion

Then 5 more checks
Code shows hereFAULTM1403

Where this code shows

On touchscreen R-series machines, touch the screen and pick Service Codes from the menu.

Checks

0 of 6 done

Causes

  • Fuse or relay feeding the fuel pull solenoid circuit open
  • Failed coil
  • Loose or broken connection
  • Vibration fatigue in the wires at the shut-off plug
1 more cause
  • Controller output not switching

How it failed

You'll notice: The fuel pull solenoid is not energising when the controller commands it.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Fuel hold, fuel pull and lift pump circuits

Source

Bobcat Service Code List (rev. 10-20, M-Series/R-Series loaders and M-Series excavators)

This source lists M1403 and its meaning. The guidance on this page is general, not taken from it.

The source covers: M-Series loaders (S450-S850, T450-T870) and M-Series excavators (E26-E85).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.