EF Logo

Volvo/Mack · MID 140 instrument cluster

Volvo/Mack Fault Code MID 140 PSID 210 FMI 12

Instrument cluster watchdog timeout (logged on DTC readout only)

What does Volvo/Mack code MID 140 PSID 210 FMI 12 mean?

The instrument cluster logs a watchdog ECU timeout. On 2018 and 2019 vehicles it appears many times on a readout and Volvo says it has no effect. Urgency: information - a reminder or status message. Check first: check for any real symptoms or other codes and diagnose those as normal.

FaultInfoMID 140PSID 210FMI 12Volvo/Mack · MID 140 instrument cluster
MID 140
Which control unit reports it
PSID 210
Maker component at fault
FMI 12
Bad intelligent device or component

Can I keep running with it?

Information

A reminder or status message. Nothing is failing yet.

What should I check first?

Check for any real symptoms or other codes and diagnose those as normal

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Instrument cluster watchdog ECU timeout in the cluster software
  • A third-party module interfering on the J1587 data link
  • Cluster powering down before other modules

How it failed

You'll notice: Nothing you can feel or see: no warning light and no change in operation.

Part or controllerRead from FMI 12: bad intelligent device or component

The controller reports a part, module or its software as faulty or not responding.

ControllerPartSupplySignalGround?
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Check power and ground at the module connector with the key on, then its fuses.
Good result
Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Volvo/Mack Solution K53357197: MID 140 PSID 210 FMI 12, Model Year 2018 (NHTSA)

This source lists MID 140 PSID 210 FMI 12 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack AN Anthem, GR Granite, PI Pinnacle and Volvo VNL, VNR, VNX, VAH, VHD, model year 2018-2019.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.