EF Logo

Volvo/Mack · MID 130 transmission ECU

Volvo/Mack Fault Code MID 130 PID 37 FMI 1

Transmission air pressure too low

What does Volvo/Mack code MID 130 PID 37 FMI 1 mean?

The air pressure supplied to the transmission is below 72.5 psi (5.0 bar). The clutch and gear actuators cannot work properly without enough air. Urgency: check soon - the machine may derate or limit a function. Check first: read air pressure in the scan tool and compare it with the cluster gauge.

FaultCheckMID 130PID 37FMI 1Volvo/Mack · MID 130 transmission ECU
MID 130
Which control unit reports it
PID 37
Parameter at fault
FMI 1
Data below normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read air pressure in the scan tool and compare it with the cluster gauge

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Low system air pressure from a leak
  • Air dryer or governor fault
  • Restricted air supply line to the transmission

How it failed

You'll notice: Yellow lamp sent, the compressed air symbol for the transmission shows, gear changes may be missing and the clutch acts slowly.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Transmission air pressure

1 other code on this part is also real condition (MID 130 PID 37 FMI 0). When they show together, start at the wiring and connector they share.

All 2 Transmission air pressure codes on one page

Source

Mack Service Bulletin 430 17 01, MID 130 Diagnostic Trouble Codes mDRIVE Transmission, PV776-89138344

This source lists MID 130 PID 37 FMI 1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.