Volvo/Mack · MID 130 transmission ECU
Volvo/Mack Fault Code MID 130 PID 36 FMI 0
Clutch wear above service limit
What does Volvo/Mack code MID 130 PID 36 FMI 0 mean?
The clutch wear reading is at or beyond the service due position. The clutch is worn out and needs to be replaced. Urgency: information - a reminder or status message. Check first: read the clutch wear value in the scan tool and note whether it follows engine load.
- MID 130
- Which control unit reports it
- PID 36
- Parameter at fault
- FMI 0
- Data above normal, most severe
Can I keep running with it?
Information
A reminder or status message. Nothing is failing yet.
What should I check first?
Read the clutch wear value in the scan tool and note whether it follows engine load
Then 3 more checksWhere to read it
Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.
Checks
0 of 4 done
Causes
- Clutch disc worn to the service limit
- Frequent heavy starts speeding up clutch wear
- Wear value not reset after a clutch replacement
How it failed
You'll notice: Yellow lamp sent.
Real conditionRead from FMI 0: data above normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other Volvo/Mack codes: MID 130 transmission ECU
- MID 130 PSID 1 FMI 3PWM valve quick engagement shorted high
- MID 130 PSID 1 FMI 5PWM valve quick engagement open circuit
- MID 130 PSID 22 FMI 3Counter shaft brake valve shorted high - brake applied
- MID 130 PSID 25 FMI 11First gear cannot engage
- MID 130 PSID 25 FMI 12Reverse gear cannot engage
- MID 130 PSID 27 FMI 0Clutch disengages unintentionally
- MID 130 PSID 27 FMI 11Clutch drag
- MID 130 PSID 27 FMI 12Clutch slipping
Related on Equipments Finder
Source
This source lists MID 130 PID 36 FMI 0 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
