EF Logo

Volvo/Mack · MID 130 transmission ECU

Volvo/Mack Fault Code MID 130 PID 177 FMI 0

Transmission oil temperature high

What does Volvo/Mack code MID 130 PID 177 FMI 0 mean?

Transmission oil is overheating. The control unit has three levels: above 100 C (212 F) for 18000 s, above 120 C (248 F) for 600 s and above 140 C (284 F) for 30 s. Urgency: stop now - shut down and fix before working on. Check first: stop and let the transmission cool if the red lamp is on.

FaultStopMID 130PID 177FMI 0Volvo/Mack · MID 130 transmission ECU
MID 130
Which control unit reports it
PID 177
Parameter at fault
FMI 0
Data above normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Stop and let the transmission cool if the red lamp is on

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 5 done

Causes

  • Transmission oil cooler blocked or low airflow
  • Low or overfilled transmission oil level
  • Heavy load or sustained climbing in too high a gear
  • Engine coolant system overheating

How it failed

You'll notice: The yellow lamp is sent and the high transmission oil temperature symbol lights; at the highest level the red stop lamp lights.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Transmission oil temperature

All 2 Transmission oil temperature codes on one page

Source

Mack Service Bulletin 430 17 01, MID 130 Diagnostic Trouble Codes mDRIVE Transmission, PV776-89138344

This source lists MID 130 PID 177 FMI 0 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.