EF Logo

Volvo/Mack · MID 128 engine ECU - module, data link and power

Volvo/Mack Fault Code MID 128 SID 232 FMI 3

Sensor supply 1 (5 V) too high

What does Volvo/Mack code MID 128 SID 232 FMI 3 mean?

The 5 V sensor supply 1 is above its allowed range. Several engine sensors share this supply, so their readings go wrong together. Urgency: check soon - the machine may derate or limit a function. Check first: measure the 5 V supply at a shared sensor connector with the key on.

FaultCheckMID 128SID 232FMI 3Volvo/Mack · MID 128 engine ECU - module, data link and power
MID 128
Which control unit reports it
SID 232
Component at fault
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure the 5 V supply at a shared sensor connector with the key on

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Sensor supply wire shorted to a higher voltage in the harness
  • Damaged harness or connector
  • A sensor sharing the supply pulling it up

How it failed

You'll notice: MIL lit and several sensor readings (pressures and temperatures) look wrong at once.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 232 FMI 3 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.