EF Logo

Volvo/Mack · MID 128 engine ECU - fuel, injectors and timing

Volvo/Mack Fault Code MID 128 SID 2 FMI 5

Injector cylinder 2 circuit open or shorted

What does Volvo/Mack code MID 128 SID 2 FMI 5 mean?

The ECM sees the cylinder 2 injector circuit as open, or the high and low sides shorted together or to ground. Cylinder 2 is not being fired properly. Urgency: check soon - the machine may derate or limit a function. Check first: measure the resistance of the cylinder 2 injector coil at its connector and compare with another cylinder.

FaultCheckMID 128SID 2FMI 5Volvo/Mack · MID 128 engine ECU - fuel, injectors and timing
MID 128
Which control unit reports it
SID 2
Component at fault
FMI 5
Current below normal or open circuit

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure the resistance of the cylinder 2 injector coil at its connector and compare with another cylinder

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Open wire to the cylinder 2 injector
  • Injector wires shorted to each other or ground
  • Cylinder 2 injector solenoid failed
  • Connector fault at the valve cover feed-through

How it failed

You'll notice: Misfire and power loss from cylinder 2, a lit MIL and yellow lamp, and an uneven idle.

Open circuitRead from FMI 5: current below normal or open circuit

No current flows, or the signal floats - a wire, pin or coil is broken.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure each wire end to end, then the part itself across its pins.
Good result
Near 0 Ω on each wire. The part reads its listed resistance, not OL.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Injector circuits (cylinders 1-6)

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 2 FMI 5 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.