Thermo King · Refrigeration system (SR-2/SR-3/SR-4)
Thermo King Fault Code 23
Cooling cycle fault
What does Thermo King code 23 mean?
The cooling cycle has failed its check outright: the unit is running in cool but not removing heat. This is the harder version of the cooling cycle check alarm. Urgency: stop now - shut down and fix before working on. Check first: fit gauges and note low suction with high superheat or no pressure difference.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Fit gauges and note low suction with high superheat or no pressure difference
Then 3 more checksWhere this code shows
Press the alarm key or open the Alarms menu on the controller display to list active alarms.
Checks
0 of 4 done
Causes
- Refrigerant lost through a leak
- Compressor damaged or not pumping
- Liquid line solenoid stuck closed
- Drive belt or clutch slipping
How it failed
You'll notice: Alarm 23 on the display and the load temperature climbs while the unit appears to run; may lock out cooling.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Make the machine safe before you start: on firm level ground, attachments down, key out.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Solenoid, expansion and heating valves and cooling and heating cycle checks
- 21Cooling cycle checkOtherCheck soon
- 22Heating cycle checkOtherCheck soon
- 23Cooling cycle faultOtherStop now
- 24Heating cycle faultOtherStop now
- 26Check refrigeration capacityOtherCheck soon
- 32Refrigeration capacity lowOtherCheck soon
- 39Check water valve circuitOtherCheck soon
- 45Check hot gas circuitOtherCheck soon
- 52Check heat circuitOtherCheck soon
Show the other 12 codesHide the other codes
- 53Check economizer valve circuitOtherCheck soon
- 67Check liquid line solenoid circuitOtherCheck soon
- 89Check electronic throttling valve (ETV) circuitOtherCheck soon
- 105Receiver tank pressure solenoid circuit checkOtherCheck soon
- 106Purge valve circuit checkOpen circuitCheck soon
- 107Condenser inlet solenoid circuit checkOtherCheck soon
- 110Suction line solenoid circuit check (zone)Lost messageCheck soon
- 113Check electric heat circuitOtherCheck soon
- 121PWM liquid injection circuit checkOpen circuitCheck soon
- 142Check Thermax valveOtherCheck soon
- 156Suction and liquid heat exchanger bypass valve checkPart or controllerCheck soon
- 175Electronic expansion valve check (CR)OtherCheck soon
Other Thermo King codes: Refrigeration system (SR-2/SR-3/SR-4)
Source
Thermo King Alarm Codes - North America (thermoking.com alarm code list)
This source lists 23 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Thermo King SR-2, SR-3, SR-4 truck and trailer units and related Thermo King controllers (the families the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
