EF Logo

John Deere · Main controller (MCZ) - options

John Deere Fault Code MCZ 11457.02

2-speed activation solenoid not detected

What does John Deere code MCZ 11457.02 mean?

The MCZ expects a 2-speed (combined pump flow) solenoid and cannot find it. If the machine does not have that kit, the code is a configuration leftover and can be cleared. Urgency: information - a reminder or status message. Check first: confirm whether the machine really has a 2-speed (combined flow) kit fitted.

FaultInfoMCZ11457.02John Deere · Main controller (MCZ) - options
MCZ
Which controller reports it
11457
What is at fault
.02
How it failed

Can I keep running with it?

Information

A reminder or status message. Nothing is failing yet.

What should I check first?

Confirm whether the machine really has a 2-speed (combined flow) kit fitted

Then 4 more checks
Code shows hereFAULTMCZ11457.02

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • No 2-speed kit fitted but the controller is set up to expect one
  • Open wire or unplugged connector to the 2-speed solenoid
  • Failed solenoid coil
  • Wrong controller option configuration after a controller swap

How it failed

You'll notice: The MCZ cannot find the 2-speed (combined flow) solenoid.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Dig, regeneration and travel speed solenoids

1 other code on this part is also lost message (MCZ 11458.02). When they show together, start at the wiring and connector they share.

Show the other 14 codes
All 23 Dig, regeneration and travel speed solenoids codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists MCZ 11457.02 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.