EF Logo

J1939 · Aftertreatment - DPF

SPN 5397 Fault Code

Aftertreatment 1 diesel particulate filter regeneration too frequent

What does SPN 5397 mean?

A detection that DPF regenerations are happening more often than normal, which usually points to excess soot production. It is used to flag an underlying engine or filter issue. How urgent it is depends on the FMI after SPN 5397 - pick it below. Check first: check the engine for faults that raise soot output, such as boost leaks and a bad injector.

FaultActiveSPN 5397FMI --J1939 engine ECU
SPN 5397
Aftertreatment 1 diesel particulate filter regeneration too frequent
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 5397 - pick it below.

What should I check first?

Check the engine for faults that raise soot output, such as boost leaks and a bad injector

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 5397?

You'll notice: The DPF is regenerating too often, so fuel use rises and you see the regeneration lamp more than normal, with possible oil dilution from the extra post-injection.

Find the number shown after SPN 5397 on your display.

  • 31SPN 5397 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 5397 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Soot production too high from an injector, air or fuel problem
  • Differential pressure sensor or hoses reading wrongly, calling for extra regenerations
  • Filter partly blocked with ash, so it fills faster
  • Duty cycle of mostly idling and low load that does not let passive regeneration happen

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 5397 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.