J1939 · Aftertreatment - DPF
SPN 5319 Fault Code
Aftertreatment 1 diesel particulate filter incomplete regeneration
What does SPN 5319 mean?
A detection that a DPF regeneration ended before it finished burning off soot. It is used to flag interrupted or insufficiently hot regenerations. How urgent it is depends on the FMI after SPN 5319 - pick it below. Check first: check that the conditions for regeneration are met: engine hot, not interrupted.
- SPN 5319
- Aftertreatment 1 diesel particulate filter incomplete regeneration
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5319 - pick it below.
What should I check first?
Check that the conditions for regeneration are met: engine hot, not interrupted
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5319?
You'll notice: A DPF regeneration started but did not finish, so soot is left in the filter.
Find the number shown after SPN 5319 on your display.
- 14SPN 5319 FMI 14: A soot sensor regeneration errorOtherDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
- 31SPN 5319 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 5319 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Regeneration interrupted by key-off, load change or low exhaust temperature
- Doser or exhaust temperature fault stopping the regeneration part-way
- Soot level sensing fault giving a wrong status
- Filter badly blocked and unable to burn off in a normal cycle
Other Aftertreatment - DPF codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 5319 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
