EF Logo

J1939 · Aftertreatment - DPF

SPN 3711 Fault Code

DPF regeneration blocked by low exhaust temperature

What does SPN 3711 mean?

A regeneration request that is being held back because exhaust temperature is too low to start it safely. How urgent it is depends on the FMI after SPN 3711 - pick it below. Check first: run the engine under load so the exhaust warms, then request the regeneration again.

FaultActiveSPN 3711FMI --J1939 engine ECU
SPN 3711
DPF regeneration blocked by low exhaust temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3711 - pick it below.

What should I check first?

Run the engine under load so the exhaust warms, then request the regeneration again

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3711?

You'll notice: Active regeneration will not start, so soot is not burned off and the DPF lamp may come on.

Find the number shown after SPN 3711 on your display.

  • 31SPN 3711 FMI 31: The condition behind the DPF regeneration blocked by low exhaust temperature fault exists and is activeReal conditionCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 1 more

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 3711 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Engine running at idle or light load so the exhaust stays cool
  • Exhaust temperature sensor reading low
  • Doser or air problem keeping temperature down
  • Cold ambient

Source

Cummins ISX15 2010-2012 fault code list (Diesel Laptops)

This list names SPN 3711 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15, Detroit DD13, Detroit DD15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.