J1939 · Aftertreatment - DPF
SPN 3696 Fault Code
DPF regeneration force switch
What does SPN 3696 mean?
Cab switch that asks the engine for a parked DPF regeneration. The request goes to the engine over the data link, usually through a body controller. How urgent it is depends on the FMI after SPN 3696 - pick it below. Check first: press and hold the force switch and watch the request in live data; it should show active and then clear when released.
- SPN 3696
- DPF regeneration force switch
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 3696 - pick it below.
What should I check first?
Press and hold the force switch and watch the request in live data; it should show active and then clear when released
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 3696?
You'll notice: A parked regeneration cannot be started from the dash, so soot cannot be cleared on demand and the DPF lamp stays on.
Find the number shown after SPN 3696 on your display.
- 4SPN 3696 FMI 4: DPF regeneration force switch signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowDetroit DD15, Detroit DD13
- 9SPN 3696 FMI 9: Abnormal update rate: the DPF regeneration force switch data is late or not arrivingLost messageDetroit DD15, Detroit DD13
- 13SPN 3696 FMI 13: The DPF regeneration force switch value is out of calibrationPart or controllerDetroit DD15, Detroit DD13
- 14SPN 3696 FMI 14: Special-instruction fault for the DPF regeneration force switch; the maker lists a dedicated procedure for itOtherDetroit DD15, Detroit DD13
- 19SPN 3696 FMI 19: Network data received for the DPF regeneration force switch is in errorLost messageDetroit DD15, Detroit DD13, PACCAR MX-13
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 3696 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Force switch stuck or worn out
- Switch wiring shorted to ground behind the dash
- Body controller losing the request message
- Data-link fault between the body controller and the engine
Other Aftertreatment - DPF codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list names SPN 3696 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13, Detroit DD15, PACCAR MX-13; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
