EF Logo

Cummins · Engine protection - SPN 1569 FMI 31

Cummins Fault Code 3714

Engine protection torque derate - most severe condition

What does Cummins code 3714 mean?

The ECM is cutting engine torque to protect the engine or the emissions system. Urgency: check soon - the machine may derate or limit a function. Check first: read every active and inactive fault with INSITE, not just 3714, and sort them by time stamp.

FaultCheck3714Cummins · Engine protection - SPN 1569 FMI 31

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read every active and inactive fault with INSITE, not just 3714, and sort them by time stamp

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Another active fault (coolant, oil pressure, boost, rail pressure or SCR system) is forcing the derate
  • Aftertreatment problem such as low DEF, poor DEF quality or a NOx sensor fault, which leads to a torque derate
  • Engine protection set after overheating or low coolant level
  • Stored fault that has not been cleared after the repair

How it failed

You'll notice: Power drops noticeably and the amber warning lamp is on.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine protection derate and SCR operator inducement

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 3714 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7 engines (J1939 SPN 1569, FMI 31); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.