EF Logo

Volvo/Mack · MID 140 instrument cluster

Volvo/Mack Fault Code MID 140 PSID 239 FMI 12

Instrument cluster - Volvo Link hardware failure, use paper logs

What does Volvo/Mack code MID 140 PSID 239 FMI 12 mean?

Counts of this code and a driver display message, Volvo Link Hardware Failure Use Paper Logs, appear when the telematics gateway (MID 142) loses communication with the instrument cluster. Urgency: check soon - the machine may derate or limit a function. Check first: check the emissions level in the Product Details of the Premium Tech Tool before choosing the procedure.

FaultCheckMID 140PSID 239FMI 12Volvo/Mack · MID 140 instrument cluster
MID 140
Which control unit reports it
PSID 239
Maker component at fault
FMI 12
Bad intelligent device or component

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the emissions level in the Product Details of the Premium Tech Tool before choosing the procedure

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Telematics gateway (TGW1) that stopped working after the 2G cellular networks shut down
  • Telematics gateway not detected in the product information
  • Low voltage during cranking or poor battery connections

How it failed

You'll notice: The driver display shows a message to use paper logs and the code counts up, sometimes after engine start.

Part or controllerRead from FMI 12: bad intelligent device or component

The controller reports a part, module or its software as faulty or not responding.

ControllerPartSupplySignalGround?
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Check power and ground at the module connector with the key on, then its fuses.
Good result
Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.

When to stop

Make the machine safe before you start: on firm level ground, attachments down, key out.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Volvo Solution K00736232: Telematics Gateway (MID 142) communication loss, MID 140 PSID 239 FMI 12 (NHTSA)

This source lists MID 140 PSID 239 FMI 12 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Volvo VNX, VNL, VNM, VHD, VAH built from late 2013 through 2017 with TGW1 or TGW2 telematics.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.