EF Logo

Volvo/Mack · MID 140 instrument cluster

Volvo/Mack Fault Code MID 140 PSID 200 FMI 9

Instrument cluster - message missing after engine software update

What does Volvo/Mack code MID 140 PSID 200 FMI 9 mean?

On some Mack ISL-G models built between 2009 and January 2013, this code sets when the engine software is updated because a message is turned off in the new engine software. Urgency: check soon - the machine may derate or limit a function. Check first: connect the Premium Tech Tool and open parameter programming for the instrument cluster (MID 140).

FaultCheckMID 140PSID 200FMI 9Volvo/Mack · MID 140 instrument cluster
MID 140
Which control unit reports it
PSID 200
Maker component at fault
FMI 9
Abnormal update rate

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Connect the Premium Tech Tool and open parameter programming for the instrument cluster (MID 140)

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • A message turned off in the new engine software
  • Instrument cluster parameter setting out of date
  • Engine software updated without matching cluster setting

How it failed

You'll notice: The cluster logs the fault after the engine software update.

Lost messageRead from FMI 9: abnormal update rate

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Make the machine safe before you start: on firm level ground, attachments down, key out.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Field Service Bulletin FSB 381-049: Instrument Cluster Reprogramming (MID 140), May 2013 (NHTSA)

This source lists MID 140 PSID 200 FMI 9 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack LEU and MRU with ISL-G engines, model years 2007-2014.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.