EF Logo

Volvo/Mack · MID 130 transmission ECU

Volvo/Mack Fault Code MID 130 PID 36 FMI 0

Clutch wear above service limit

What does Volvo/Mack code MID 130 PID 36 FMI 0 mean?

The clutch wear reading is at or beyond the service due position. The clutch is worn out and needs to be replaced. Urgency: information - a reminder or status message. Check first: read the clutch wear value in the scan tool and note whether it follows engine load.

FaultInfoMID 130PID 36FMI 0Volvo/Mack · MID 130 transmission ECU
MID 130
Which control unit reports it
PID 36
Parameter at fault
FMI 0
Data above normal, most severe

Can I keep running with it?

Information

A reminder or status message. Nothing is failing yet.

What should I check first?

Read the clutch wear value in the scan tool and note whether it follows engine load

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Clutch disc worn to the service limit
  • Frequent heavy starts speeding up clutch wear
  • Wear value not reset after a clutch replacement

How it failed

You'll notice: Yellow lamp sent.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Service Bulletin 430 17 01, MID 130 Diagnostic Trouble Codes mDRIVE Transmission, PV776-89138344

This source lists MID 130 PID 36 FMI 0 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.