EF Logo

Volvo/Mack · MID 130 transmission ECU

Volvo/Mack Fault Code MID 130 PID 158 FMI 1

Transmission control unit battery voltage low

What does Volvo/Mack code MID 130 PID 158 FMI 1 mean?

On a 12 V system the supply voltage to the transmission control unit is below 9 V after the engine has run for 5 seconds. Urgency: check soon - the machine may derate or limit a function. Check first: measure battery voltage at rest and with the engine running.

FaultCheckMID 130PID 158FMI 1Volvo/Mack · MID 130 transmission ECU
MID 130
Which control unit reports it
PID 158
Parameter at fault
FMI 1
Data below normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure battery voltage at rest and with the engine running

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Weak battery or charging fault
  • Poor power or ground connection at the control unit
  • Corroded battery cables

How it failed

You'll notice: Yellow lamp sent and transmission performance is reduced while the supply stays low.

Real conditionRead from FMI 1: data below normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Service Bulletin 430 17 01, MID 130 Diagnostic Trouble Codes mDRIVE Transmission, PV776-89138344

This source lists MID 130 PID 158 FMI 1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack CHU, CXU, GU and TD trucks with the mDRIVE automated transmission (MID 130 transmission control unit).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.