EF Logo

Volvo/Mack · MID 128 engine ECU - sensors and levels

Volvo/Mack Fault Code MID 128 SID 33 FMI 3

Fan clutch output shorted high - fan runs full speed

What does Volvo/Mack code MID 128 SID 33 FMI 3 mean?

The engine fan clutch driver is shorted to positive. The ECM cannot control the fan and it stays engaged. Urgency: check soon - the machine may derate or limit a function. Check first: watch fan speed in the scan tool; it should vary with temperature.

FaultCheckMID 128SID 33FMI 3Volvo/Mack · MID 128 engine ECU - sensors and levels
MID 128
Which control unit reports it
SID 33
Component at fault
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch fan speed in the scan tool; it should vary with temperature

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • Short to positive in the cooling fan control circuit
  • Faulty cooling fan actuator
  • Damaged harness or connector at the fan actuator

How it failed

You'll notice: The fan roars at full speed all the time, fuel consumption rises and a yellow check lamp is lit.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Fan clutch control

All 3 Fan clutch control codes on one page

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 33 FMI 3 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.