EF Logo

Volvo/Mack · MID 128 engine ECU - module, data link and power

Volvo/Mack Fault Code MID 128 SID 231 FMI 2

SAE J1939 data link (CAN 1) circuit fault

What does Volvo/Mack code MID 128 SID 231 FMI 2 mean?

The engine ECM detected a problem on the J1939 CAN 1 data link. Mack lists the CAN high or low shorted to positive or ground, or open. Urgency: check soon - the machine may derate or limit a function. Check first: measure resistance across the CAN high and low pins at the diagnostic connector with the key off; the pair should read about 60 ohms.

FaultCheckMID 128SID 231FMI 2Volvo/Mack · MID 128 engine ECU - module, data link and power
MID 128
Which control unit reports it
SID 231
Component at fault
FMI 2
Erratic or incorrect data

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure resistance across the CAN high and low pins at the diagnostic connector with the key off; the pair should read about 60 ohms

Then 3 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect the Premium Tech Tool or a J1939/J1587 scan tool to the diagnostic socket and read the codes for every module, not only the engine.

Checks

0 of 4 done

Causes

  • CAN high or low shorted to positive
  • CAN high or low shorted to ground
  • CAN high or low circuit open
  • Damaged connector on the data link harness

How it failed

You'll notice: MIL lit and several modules can lose communication, which can show as missing gauges, no cruise or limited engine power.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Mack Group 28 Engine Control Module (ECM) Diagnostic Trouble Code Guide, 2010 Emissions CHU/CXU/GU/TD, PV776-89047073 (MID 128 PID/SID tables)

This source lists MID 128 SID 231 FMI 2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Mack MP7/MP8/MP10 engines (CHU, CXU, GU, TD) with the 2010-and-later MID 128 engine ECU; the same MID 128 numbers appear on Volvo D11/D13 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.