EF Logo

Thermo King · Engine speed and starting (SR-2/SR-3/SR-4)

Thermo King Fault Code 20

Engine failed to start

What does Thermo King code 20 mean?

The engine cranked for the full attempt time but never fired and held RPM. The controller gave up and logged the alarm. Urgency: stop now - shut down and fix before working on. Check first: check the fuel tank level and the shutoff valve position.

FaultStop20Thermo King · Engine speed and starting (SR-2/SR-3/SR-4)

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check the fuel tank level and the shutoff valve position

Then 4 more checks
Code shows hereFAULT20

Where this code shows

Press the alarm key or open the Alarms menu on the controller display to list active alarms.

Checks

0 of 5 done

Causes

  • Out of fuel or fuel valve closed
  • Air in the fuel lines or clogged filter
  • Fuel solenoid not energised
  • Cold weather with failed glow plugs
1 more cause
  • Low battery cranking too slowly

How it failed

You'll notice: Engine turns over but does not start; after repeated attempts alarm 20 shows and the unit stays off.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine starting, glow plugs and engine speed

Source

Thermo King Alarm Codes - North America (thermoking.com alarm code list)

This source lists 20 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Thermo King SR-2, SR-3, SR-4 truck and trailer units and related Thermo King controllers (the families the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.