EF Logo

Skyjack · GP102 module LED flash codes

Skyjack Fault Code 2‑1

Elevation switch shifted?

What does Skyjack code 2-1 mean?

The module sees the elevation switch change state at a platform position where it should not. That points at the switch, its mounting or the arm that operates it. Urgency: check soon - the machine may derate or limit a function. Check first: raise and lower the platform slowly and watch the switch operate; it must change state at the same point every time.

FaultCheck2-1Skyjack · GP102 module LED flash codes

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Raise and lower the platform slowly and watch the switch operate; it must change state at the same point every time

Then 4 more checks
Code shows hereFAULT2-1

Where this code shows

Find the LED on the GP102 module (older SJIII scissors) or the display and keypad in the hydraulic tray (Skycoded machines).

Checks

0 of 5 done

Causes

  • Elevation switch loose on its bracket so it has moved out of position
  • Operating arm or cam bent or worn
  • Switch contacts dirty or intermittent
  • Wire rubbing at the scissor arm pivot

How it failed

You'll notice: Drive and lift can be cut because the machine thinks the platform is in the wrong height zone.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Tilt, overload, armguard and elevation switch codes

Source

Skyjack SJIII 3215/3219 Service Manual 155147AD (Nov 2013), sections 5.3-2 and 5.3-3, LED Error Codes, pp. 9-11

This source lists 2-1 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Skyjack SJIII 3215 and 3219 DC electric scissors with the GP102 module (manual 155147AD, serials 10,000,574-10,000,630 and 22,019,597-22,022,792); later serial ranges can differ, check your own manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.