EF Logo

Skyjack · GP102 module LED flash codes

Skyjack Fault Code 1‑2

Vehicle overloaded

What does Skyjack code 1-2 mean?

The pressure transducer on the lift cylinder tells the GP102 module the platform load is above the rated limit. The module cuts lift and drive until the extra weight is removed, so it is a load message, not a fault in the module. Urgency: information - a reminder or status message. Check first: take the load off and compare what was on the platform with the capacity plate.

FaultInfo1-2Skyjack · GP102 module LED flash codes

Can I keep running with it?

Information

A reminder or status message. Nothing is failing yet.

What should I check first?

Take the load off and compare what was on the platform with the capacity plate

Then 4 more checks
Code shows hereFAULT1-2

Where this code shows

Find the LED on the GP102 module (older SJIII scissors) or the display and keypad in the hydraulic tray (Skycoded machines).

Checks

0 of 5 done

Causes

  • More people, tools or material on the platform than the rated capacity
  • Platform pressed against a beam or ceiling, which adds to the cylinder pressure
  • Lift cylinder pressure transducer reading high or out of calibration
  • Load calibration lost after a battery or module change

How it failed

You'll notice: The red power light on the platform console flashes and the audible alarm sounds, all electric movement stops, and the LED shows one flash then two flashes.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Tilt, overload, armguard and elevation switch codes

Source

Skyjack SJIII 3215/3219 Service Manual 155147AD (Nov 2013), sections 5.3-2 and 5.3-3, LED Error Codes, pp. 9-11

This source lists 1-2 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Skyjack SJIII 3215 and 3219 DC electric scissors with the GP102 module (manual 155147AD, serials 10,000,574-10,000,630 and 22,019,597-22,022,792); later serial ranges can differ, check your own manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.