EF Logo

Kubota · DPF regeneration (E:90xx)

Kubota Fault Code E:9004

DPF replacement required

What does Kubota code E:9004 mean?

The particulate filter is so loaded with ash and soot that regeneration cannot restore it. The filter has to be serviced or replaced and the engine may be limited. Urgency: stop now - shut down and fix before working on. Check first: review history for repeated failed regenerations.

FaultStopE:9004Kubota · DPF regeneration (E:90xx)

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Review history for repeated failed regenerations

Then 4 more checks
Code shows hereFAULTE:9004

Where this code shows

Watch the meter panel: a warning lamp comes on and the E: code scrolls on the display.

Checks

0 of 5 done

Causes

  • Filter loaded with ash beyond what regeneration can burn
  • Long period of unsuccessful regenerations
  • Engine fault pushing excess soot into the exhaust
  • Cracked or melted DPF substrate

How it failed

You'll notice: Red DPF lamp with E:9004; reduced engine power or limited operation until the filter is serviced.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: DPF, regeneration and particulate accumulation

Show the other 15 codes
All 24 DPF, regeneration and particulate accumulation codes on one page

Source

CodeReady - Kubota Skid Steer Loader Error Codes (SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2), error code table

This source lists E:9004 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Kubota SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2 loaders (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.