EF Logo

Kubota · Loader controller (E:0xx)

Kubota Fault Code E:004

Hydraulic oil temperature advance warning

What does Kubota code E:004 mean?

The hydraulic oil temperature is climbing toward its limit and the loader warns you before it gets there. If work continues the code moves on to E:005 and the machine starts protecting itself. Urgency: check soon - the machine may derate or limit a function. Check first: park, idle the engine and inspect the cooler core from both sides; blow out any packed debris with air.

FaultCheckE:004Kubota · Loader controller (E:0xx)

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Park, idle the engine and inspect the cooler core from both sides; blow out any packed debris with air

Then 4 more checks
Code shows hereFAULTE:004

Where this code shows

Watch the meter panel: a warning lamp comes on and the E: code scrolls on the display.

Checks

0 of 5 done

Causes

  • Oil cooler fins packed with dirt, chaff or debris
  • Cooling fan or its speed solenoid not reaching full speed
  • Hydraulic oil level low or oil too thin after a long hot shift
  • Circuit relieving constantly because an attachment is held at the end of its stroke

How it failed

You'll notice: Oil temperature warning on the meter with E:004; the loader still works at full strength but is heating up.

OtherRead from how the source describes the code

The source does not say how this one failed.

Meter test
Read the code with the service tool and note which other codes are active with it.
Good result
Codes that appear together usually share one cause - start with the wiring they share.

When to stop

Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Loader hydraulic controls and solenoids

Source

CodeReady - Kubota Skid Steer Loader Error Codes (SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2), error code table

This source lists E:004 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Kubota SSV65, SSV75, SVL65-2, SVL75-3, SVL97-2 loaders (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.