EF Logo

Komatsu · Engine controller

Komatsu Fault Code CA322

Injector #1 (L#1) open or short circuit

What does Komatsu code CA322 mean?

The engine controller finds an open or shorted circuit on injector #1 (L#1). That cylinder can misfire or stop injecting, so the engine runs rough and loses power. Urgency: check soon - the machine may derate or limit a function. Check first: measure the coil resistance of injector #1 at its connector and compare it with the other five.

FaultCheckCA322Komatsu · Engine controller

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure the coil resistance of injector #1 at its connector and compare it with the other five

Then 4 more checks
Code shows hereFAULTCA322

Where this code shows

Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.

Checks

0 of 5 done

Causes

  • Connector at injector #1 under the valve cover loose or corroded
  • Wire to injector #1 rubbed through at the cylinder head
  • Open or shorted coil in injector #1
  • Engine controller driver for cylinder 1 failed

How it failed

You'll notice: Engine runs on five cylinders, rough with less power, with CA322 on the monitor.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Injector and IMV solenoid circuits

Source

SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)

This source lists CA322 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.