Komatsu · Engine controller
Komatsu Fault Code CA111
Engine controller critical internal error
What does Komatsu code CA111 mean?
The engine controller detects a critical internal fault in its own hardware. It may shut the engine down or refuse to start. Urgency: stop now - shut down and fix before working on. Check first: check battery voltage and the controller power and ground wires.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Check battery voltage and the controller power and ground wires
Then 4 more checksWhere this code shows
Watch the monitor for the user code and the caution lamp or buzzer, and write the code down.
Checks
0 of 5 done
Causes
- Low supply voltage or poor ground to the controller
- Water or corrosion in the controller connector
- Failed controller after an electrical event such as jump starting or welding
How it failed
Part or controllerRead from how the source describes the code
The controller reports a part, module or its software as faulty or not responding.
- Meter test
- Check power and ground at the module connector with the key on, then its fuses.
- Good result
- Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine controller internal and network faults
- CA111Engine controller critical internal errorPart or controllerStop now
- CA757All continuous data lostOtherCheck soon
- 989L00Engine controller lock warning 1OtherCheck soon
- 989M00Engine controller lock warning 2OtherCheck soon
- 989N00Engine controller lock warning 3OtherCheck soon
- CA1633KOMNET data link timeoutLost messageCheck soon
Other Komatsu codes: Engine controller
Related on Equipments Finder
Source
SINOCMP - Error Code List for Komatsu PC200-8, PC220-8 and PC220LC-8 Excavators (failure code table)
This source lists CA111 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Komatsu PC200-8, PC220-8 and PC220LC-8 excavators (the models the source lists).
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
