John Deere · Main controller (MCZ) - alarms
John Deere Fault Code MCZ 20062.02
Hydraulic oil temperature alarm
What does John Deere code MCZ 20062.02 mean?
The hydraulic oil temperature is above the alarm limit. Continued work can damage seals, hoses and pumps, and the operator may see the temperature gauge in the red and reduced hydraulic performance. Urgency: stop now - shut down and fix before working on. Check first: stop work and let the machine idle to cool, then check the cooler and radiator for debris.
- MCZ
- Which controller reports it
- 20062
- What is at fault
- .02
- How it failed
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Stop work and let the machine idle to cool, then check the cooler and radiator for debris
Then 4 more checksWhere this code shows
Turn the key on and open the monitor's diagnostic/fault screen.
Checks
0 of 5 done
Causes
- Oil cooler blocked or the fan not turning fast enough
- Hydraulic oil level low or the wrong oil in the system
- A relief valve or pump leaking internally and turning hydraulic power into heat
- Oil temperature sensor reading wrongly
How it failed
You'll notice: The hydraulic oil temperature has passed the alarm limit.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Hydraulic, pilot and machine alarms
1 other code on this part is also lost message (MCZ 20009.02). When they show together, start at the wiring and connector they share.
- MCZ 20009.02Hydraulic oil cooling system abnormalLost messageCheck soon
- MCZ 20011.02Electric lever alarmErratic or implausibleCheck soon
- MCZ 20012.02Line filter restriction alarmReal conditionCheck soon
- MCZ 20013.02Hydraulic fan low rotation warningOtherCheck soon
- MCZ 20062.02Hydraulic oil temperature alarmLost messageStop now
- DSZ 20105.02Hydraulic oil filter restriction alarmShorted highCheck soon
- ICZ 20105.02Hydraulic oil filter restriction alarmShorted highCheck soon
- DSZ 20109.02Pilot control shut-off lever alarmOtherCheck soon
- ICZ 20109.02Pilot control shut-off lever alarmOtherCheck soon
Show the other 5 codesHide the other codes
Other John Deere codes: Main controller (MCZ) - alarms
Related on Equipments Finder
Source
Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)
This source lists MCZ 20062.02 and its meaning. The guidance on this page is general, not taken from it.
The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
