EF Logo

John Deere · Engine control unit (ECU) - Electrical

John Deere Fault Code ECU 000158.01

Battery voltage low

What does John Deere code ECU 000158.01 mean?

The ECU sees its supply voltage drop below the lower limit. Low supply can set other communication codes, cause the engine to stall or restart poorly, and the operator may see a battery warning. Urgency: check soon - the machine may derate or limit a function. Check first: measure battery voltage with the engine off and again with the engine running.

FaultCheckECU000158.01John Deere · Engine control unit (ECU) - Electrical
ECU
Which controller reports it
.01
Data below normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure battery voltage with the engine off and again with the engine running

Then 4 more checks
Code shows hereFAULTECU000158.01

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Weak or discharged batteries
  • Loose or corroded battery terminals or earth straps
  • Alternator not charging
  • High resistance in the ECU supply wire or fuse holder

How it failed

You'll notice: The ECU supply voltage has dropped below its limit.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Battery, alternator and tractor basic control unit (BCU)

5 other codes on this part are also shorted low (ECU 000158.17, BCU 000168.17, BCU 000168.18, ECU 000627.01 and more). When they show together, start at the wiring and connector they share.

Show the other 13 codes
All 22 Battery, alternator and tractor basic control unit (BCU) codes on one page

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists ECU 000158.01 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.