EF Logo

John Deere · Engine control unit (ECU) - Engine air

John Deere Fault Code ECU 000107.00

Air filter differential pressure high

What does John Deere code ECU 000107.00 mean?

The engine ECU sees air filter restriction at the most severe level. Urgency: check soon - the machine may derate or limit a function. Check first: take the air cleaner element out and look at it against a light; a dark clogged element confirms the cause.

FaultCheckECU000107.00John Deere · Engine control unit (ECU) - Engine air
ECU
Which controller reports it
.00
Data above normal, most severe

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Take the air cleaner element out and look at it against a light; a dark clogged element confirms the cause

Then 4 more checks
Code shows hereFAULTECU000107.00

Where this code shows

Turn the key on and open the monitor's diagnostic/fault screen.

Checks

0 of 5 done

Causes

  • Air cleaner element clogged with dust, especially after work in dry or dusty ground
  • Dust cap or pre-cleaner packed so air cannot get in
  • Intake pipe collapsed or a hose soft on the suction side
  • Air filter restriction sensor or its wiring faulty

How it failed

You'll notice: The engine ECU sees the air filter restriction at its worst level.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Air filter, exhaust filter, fuel level and monitor sensors

Source

Excavator Fault Codes - John Deere excavators fault codes list (MCZ/ECU/DSZ)

This source lists ECU 000107.00 and its meaning. The guidance on this page is general, not taken from it.

The source covers: John Deere G-series excavators (210G/210GLC and 350G class) with MCZ main controller; confirm against serial number.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.