EF Logo

JLG · Engine

JLG Fault Code 438

High engine temperature

What does JLG code 438 mean?

Engine coolant temperature is above its limit (about 117 C Ford, 130 C Deutz). The controller may reduce engine output or shut the engine down. Urgency: stop now - shut down and fix before working on. Check first: stop the engine and let it cool before opening the cap, then check the coolant level and look for leaks.

FaultStop438JLG · Engine

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Stop the engine and let it cool before opening the cap, then check the coolant level and look for leaks

Then 4 more checks
Code shows hereFAULT438

Where this code shows

Turn the key on and watch the fault lamp or platform display.

Checks

0 of 5 done

Causes

  • Low coolant level or a leak
  • Radiator fins blocked with dirt or chaff
  • Cooling fan or drive belt failed
  • Thermostat stuck closed
1 more cause
  • Coolant temperature sensor reading high

How it failed

You'll notice: A high engine temperature warning appears and the engine may be derated or shut down.

Real conditionRead from how the source describes the code

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Engine speed, temperature, oil pressure, fuel level and ECM

Source

JLG 600S/660SJ Service and Maintenance Manual 3121298, section 6 (Table 6-8 Fault Code List)

This source lists 438 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JLG 600S, 600SJ, 660SJ with newer module software; same DTC scheme on other JLG Control System booms, confirm in your manual.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.