JLG · Engine
JLG Fault Code 4311
Low oil pressure
What does JLG code 4311 mean?
Engine oil pressure is low (Deutz: under about 8 PSI after 10 s of running). The controller may shut the engine down to protect it. Urgency: stop now - shut down and fix before working on. Check first: shut the engine down and check the oil level on the dipstick and top up if low.
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Shut the engine down and check the oil level on the dipstick and top up if low
Then 4 more checksWhere this code shows
Turn the key on and watch the fault lamp or platform display.
Checks
0 of 5 done
Causes
- Low engine oil level
- Worn engine bearings or oil pump
- Faulty oil pressure sender
- Wiring to the oil pressure sender damaged
1 more causeFewer causes
- Oil too thin or wrong grade after a top-up
How it failed
You'll notice: A low oil pressure warning shows and the controller may shut the engine down, so the machine stops mid-task.
OtherRead from how the source describes the code
The source does not say how this one failed.
- Meter test
- Read the code with the service tool and note which other codes are active with it.
- Good result
- Codes that appear together usually share one cause - start with the wiring they share.
When to stop
Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Engine speed, temperature, oil pressure, fuel level and ECM
- 433Oil Pressure - short to batteryShorted highCheck soon
- 434Oil Pressure - short to groundShorted lowCheck soon
- 435Coolant Temperature - short to groundShorted lowCheck soon
- 437Engine trouble codeOtherCheck soon
- 438High engine temperatureReal conditionStop now
- 4311Low oil pressureOtherStop now
- 4314Wrong engine selected - ECM detectedOtherCheck soon
- 4322Loss of engine speed sensorOtherCheck soon
- 4323Speed sensor reading invalid speedReal conditionCheck soon
Show the other 6 codesHide the other codes
Other JLG codes: Engine
Related on Equipments Finder
Source
JLG 600S/660SJ Service and Maintenance Manual 3121298, section 6 (Table 6-8 Fault Code List)
This source lists 4311 and its meaning. The guidance on this page is general, not taken from it.
The source covers: JLG 600S, 600SJ, 660SJ with newer module software; same DTC scheme on other JLG Control System booms, confirm in your manual.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
