JCB · Engine ECU (Dieselmax / Ecomax) - electrical
JCB Fault Code P0562
System voltage low
What does JCB code P0562 mean?
Supply voltage reaching the engine ECU fell below about 10 to 11.5 V while the engine was running. Expect warning lights, erratic gauges, hard starting or the ECU resetting. Urgency: check soon - the machine may derate or limit a function. Check first: measure battery voltage with the engine off and again at fast idle.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Measure battery voltage with the engine off and again at fast idle
Then 5 more checksWhere this code shows
Switch the key on and note any warning lamp or fault icon on the cluster.
Checks
0 of 6 done
Causes
- Weak or old battery that cannot hold voltage under load
- Alternator not charging, or a slipping belt
- Loose or corroded battery terminals or earth strap
- High resistance in the main supply to the ECU, such as a poor ignition feed
1 more causeFewer causes
- Heavy electrical load or a short pulling the system down
How it failed
You'll notice: Lights dim, gauges act up and the engine can be hard to start or cut out when the voltage drops.
Shorted lowRead from how the source describes the code
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: System voltage, charging, warning lamps and service interval
2 other codes on this part are also shorted low (C1026, C1028). When they show together, start at the wiring and connector they share.
- B130ASupplementary service interval due / elapsedOtherInformation
- P0560System voltage faultOtherCheck soon
- P0562System voltage lowShorted lowCheck soon
- P0563System voltage highShorted highCheck soon
- P0650Malfunction indicator lamp control circuit faultOtherInformation
- P0655Engine test indicator lamp malfunctionOtherInformation
- B1002Alternator not chargingOtherCheck soon
- C1025Battery voltage high faultShorted highCheck soon
- C1026Battery voltage low faultShorted lowCheck soon
Show the other 4 codesHide the other codes
Other JCB codes: Engine ECU (Dieselmax / Ecomax) - electrical
Related on Equipments Finder
Source
Partao JCB fault code P0562 page
This source lists P0562 and its meaning. The guidance on this page is general, not taken from it.
The source covers: 3CX, 3DX, JS130, JS220, JS235, Loadalls, T4i/T4F/Stage V.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
