EF Logo

JCB · Engine ECU (Dieselmax / Ecomax) - temperature sensors

JCB Fault Code P0118

Coolant temperature sensor signal high

What does JCB code P0118 mean?

The voltage from the coolant sensor is too high, which reads as an extremely cold engine, usually an open circuit. Urgency: check soon - the machine may derate or limit a function. Check first: read the live coolant temperature with the engine warm and confirm it is stuck at a very low value.

FaultCheckP0118JCB · Engine ECU (Dieselmax / Ecomax) - temperature sensors

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read the live coolant temperature with the engine warm and confirm it is stuck at a very low value

Then 5 more checks
Code shows hereFAULTP0118

Where this code shows

Switch the key on and note any warning lamp or fault icon on the cluster.

Checks

0 of 6 done

Causes

  • Open circuit in the coolant sensor wiring near the thermostat housing
  • Coolant sensor unplugged, or its pins corroded by coolant seepage
  • Signal wire shorted to the 5 V reference or to supply
  • Coolant temperature sensor failed open
1 more cause
  • Wire broken at the plug from engine vibration

How it failed

You'll notice: The ECU thinks the coolant is stone cold on a warm engine, so it may idle fast, smoke white, run rich and start hard when hot, and the cab temperature gauge reads low or not at all.

Open circuitRead from how the source describes the code

No current flows, or the signal floats - a wire, pin or coil is broken.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure each wire end to end, then the part itself across its pins.
Good result
Near 0 Ω on each wire. The part reads its listed resistance, not OL.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Fuel, oil and coolant temperature sensors and engine overheating

Source

Partao JCB fault code P0118 page

This source lists P0118 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JS140, JS205, JS215 and 212.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.