EF Logo

JCB · Engine ECU (Dieselmax / Ecomax) - temperature sensors

JCB Fault Code P0117

Coolant temperature sensor signal low

What does JCB code P0117 mean?

The voltage from the coolant sensor is too low, which reads as an impossibly hot engine, usually a short to ground. Urgency: check soon - the machine may derate or limit a function. Check first: with key on, read the live temperature and check it reads an impossibly high value.

FaultCheckP0117JCB · Engine ECU (Dieselmax / Ecomax) - temperature sensors

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

With key on, read the live temperature and check it reads an impossibly high value

Then 5 more checks
Code shows hereFAULTP0117

Where this code shows

Switch the key on and note any warning lamp or fault icon on the cluster.

Checks

0 of 6 done

Causes

  • Signal wire shorted to ground
  • Coolant temperature sensor shorted internally
  • Water in the connector bridging the signal pin to ground
  • Harness rubbed through against the engine or a bracket
1 more cause
  • Damaged ECU input, which is rare

How it failed

You'll notice: The ECU thinks the engine is extremely hot, so the cooling fans may run flat out, the temperature gauge may swing high and the engine may derate even though the coolant is normal.

Shorted lowRead from how the source describes the code

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Fuel, oil and coolant temperature sensors and engine overheating

Source

Partao JCB fault code P0117 page

This source lists P0117 and its meaning. The guidance on this page is general, not taken from it.

The source covers: 2CX-5CX, Loadall, tracked excavators, wheeled loaders, site dumpers, rough terrain forklifts, EcoMax 444.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.