EF Logo

JCB · Machine controller (MECU / DECU)

JCB Fault Code C1025

Battery voltage high fault

What does JCB code C1025 mean?

Battery voltage as seen by the controller is above its limit. The operator may see a charging warning, and electronics can be damaged by sustained overvoltage. Urgency: check soon - the machine may derate or limit a function. Check first: measure battery voltage with the engine running and compare it with the controller reading.

FaultCheckC1025JCB · Machine controller (MECU / DECU)

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure battery voltage with the engine running and compare it with the controller reading

Then 5 more checks
Code shows hereFAULTC1025

Where this code shows

Switch the key on and note any warning lamp or fault icon on the cluster.

Checks

0 of 6 done

Causes

  • Alternator regulator failed high
  • Poor earth or sensing wire letting the alternator overcharge
  • Loose battery terminal confusing the voltage reading
  • Wrong or failed battery
1 more cause
  • Controller voltage sensing wire damaged

How it failed

You'll notice: The controller sees battery voltage above its limit.

Shorted highRead from how the source describes the code

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: System voltage, charging, warning lamps and service interval

Source

Partao JCB fault code list, page 2 (code table)

This source lists C1025 and its meaning. The guidance on this page is general, not taken from it.

The source covers: JCB machines with MECU/DECU.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.