J1939 · Aftertreatment - DPF
SPN 5747 Fault Code
Soot sensor heater
What does SPN 5747 mean?
Heater inside the soot sensor that brings the element to temperature and burns off deposits. How urgent it is depends on the FMI after SPN 5747 - pick it below. Check first: measure the heater resistance at the sensor connector and compare it with the manual range.
- SPN 5747
- Soot sensor heater
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5747 - pick it below.
What should I check first?
Measure the heater resistance at the sensor connector and compare it with the manual range
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5747?
You'll notice: The sensor cannot condition itself, so it may fail its self-checks and the DPF monitor stops working.
Find the number shown after SPN 5747 on your display.
- 1SPN 5747 FMI 1: Soot sensor heater is below the normal range, most severe levelReal conditionPACCAR MX-13
- 3SPN 5747 FMI 3: Soot sensor heater signal voltage is above normal, or the circuit is shorted to a high sourceShorted highPACCAR MX-13
- 4SPN 5747 FMI 4: Soot sensor heater signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowPACCAR MX-13
- 10SPN 5747 FMI 10: Soot sensor heater is changing at an abnormal rateErratic or implausiblePACCAR MX-13
- 12SPN 5747 FMI 12: Failure inside the device or component that handles the Soot sensor heaterPart or controllerDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 5747 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Sensor heater open or shorted
- Supply to the sensor control unit missing
- Sensor connector corrosion
- Control unit driver failed
Other Aftertreatment - DPF codes
Source
PACCAR MX-13 2013-2016 fault codes list (Diesel Laptops)
This list names SPN 5747 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13, Detroit DD15, PACCAR MX-13; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
