EF Logo

J1939 · Aftertreatment - DPF

SPN 5569 Fault Code

Soot sensor control unit temperature

What does SPN 5569 mean?

Temperature inside the soot sensor control unit, used to protect its electronics from heat. How urgent it is depends on the FMI after SPN 5569 - pick it below. Check first: check the control unit mounting, bracket and heat shielding against the manual.

FaultActiveSPN 5569FMI --J1939 engine ECU
SPN 5569
Soot sensor control unit temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 5569 - pick it below.

What should I check first?

Check the control unit mounting, bracket and heat shielding against the manual

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 5569?

You'll notice: The soot sensor may be shut off for protection, so the DPF monitor cannot work.

Find the number shown after SPN 5569 on your display.

  • 2SPN 5569 FMI 2: Soot sensor control unit temperature data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15
  • 3SPN 5569 FMI 3: Soot sensor control unit temperature signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 1 more
  • 4SPN 5569 FMI 4: Soot sensor control unit temperature signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 1 more
  • 16SPN 5569 FMI 16: Soot sensor control unit temperature is above the normal range, moderately severe levelReal conditionCummins ISX15

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 5569 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Control unit too near the exhaust with its heat shield missing
  • Internal temperature sensor failed
  • Control unit supply fault
  • Loose bracket letting it sit against hot pipe

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 5569 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15, Detroit DD13, Detroit DD15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.