J1939 · Fuel system
SPN 5323 Fault Code
Closed-loop fuel pressure entry time
What does SPN 5323 mean?
The time the system takes to move from open-loop to closed-loop control of fuel rail pressure at start-up. How urgent it is depends on the FMI after SPN 5323 - pick it below. Check first: prime the fuel system, then watch rail pressure on the first start and see how fast it rises.
- SPN 5323
- Closed-loop fuel pressure entry time
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 5323 - pick it below.
What should I check first?
Prime the fuel system, then watch rail pressure on the first start and see how fast it rises
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 5323?
You'll notice: The engine takes too long to settle after start, so it may idle poorly, set a rail-pressure code and run with reduced power.
Find the number shown after SPN 5323 on your display.
- 13SPN 5323 FMI 13: The Closed-loop fuel pressure entry time value is out of calibrationPart or controllerDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
Checks
0 of 5 done
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
How urgent SPN 5323 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Air in the fuel
- Weak lift pump
- Clogged fuel filter
- Rail pressure sensor reading slow
Other Fuel system codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list names SPN 5323 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13, Detroit DD15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
