J1939 · Aftertreatment - DPF
SPN 4796 Fault Code
Aftertreatment 1 diesel oxidation catalyst missing
What does SPN 4796 mean?
A detection that the DOC appears to be absent, inferred from exhaust temperature behaviour. It is used to catch removed or deleted catalysts. How urgent it is depends on the FMI after SPN 4796 - pick it below. Check first: inspect the exhaust and confirm the DOC is fitted and intact.
- SPN 4796
- Aftertreatment 1 diesel oxidation catalyst missing
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 4796 - pick it below.
What should I check first?
Inspect the exhaust and confirm the DOC is fitted and intact
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 4796?
You'll notice: The ECM believes the diesel oxidation catalyst is missing or has been removed, so it logs a fault.
Find the number shown after SPN 4796 on your display.
- 31SPN 4796 FMI 31: A condition exists: the ECM is flagging a defined state rather than a circuit failureReal conditionCummins ISX15
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 4796 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- DOC removed or replaced with a plain pipe
- DOC temperature sensors reading wrongly, so no heat rise appears across the catalyst
- Doser or fuel supply fault leaving no heat to generate across the DOC
- DOC damaged or washed out so it no longer reacts
Other Aftertreatment - DPF codes
- SPN 5018Diesel oxidation catalyst plugged
- SPN 5298Diesel oxidation catalyst conversion efficiency
- SPN 3556Aftertreatment doser (hydrocarbon injector)
- SPN 81DPF intake pressure
- SPN 3242DPF intake temperature sensor
- SPN 3245DPF outlet temperature
- SPN 3246DPF outlet temperature sensor
- SPN 3249DPF intake temperature
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 4796 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
