EF Logo

J1939 · Aftertreatment - DPF

SPN 3720 Fault Code

Aftertreatment 1 diesel particulate filter ash load

What does SPN 3720 mean?

The ECM's estimate of how much ash, which cannot be burned off, has built up in the DPF. It is used to schedule filter cleaning. How urgent it is depends on the FMI after SPN 3720 - pick it below. Check first: check the ash load and the hours since the last DPF cleaning in the service tool.

FaultActiveSPN 3720FMI --J1939 engine ECU
SPN 3720
Aftertreatment 1 diesel particulate filter ash load
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3720 - pick it below.

What should I check first?

Check the ash load and the hours since the last DPF cleaning in the service tool

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3720?

You'll notice: The ash load in the DPF is high or out of range, so the filter is near its cleaning interval.

Find the number shown after SPN 3720 on your display.

  • 0SPN 3720 FMI 0: Value is above the normal range, most severe levelReal conditionMack MP8, Mack MP7, Volvo D13
  • 14SPN 3720 FMI 14: The aftertreatment controller reports an ash mileage lower than the engine controller's stored valueOtherDetroit DD15, Detroit DD13
  • 15SPN 3720 FMI 15: Value is above the normal range, least severe levelReal conditionCummins ISX15

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 3720 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Ash built up over the service life from engine oil additives
  • Wrong engine oil with a high ash content for the DPF
  • Excess oil consumption feeding extra ash into the filter
  • Ash counter not reset after a DPF cleaning or replacement

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 3720 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.