EF Logo

J1939 · Aftertreatment - DPF

SPN 3482 Fault Code

Aftertreatment 1 fuel shutoff valve

What does SPN 3482 mean?

The valve that opens to feed fuel to the aftertreatment doser and closes when not needed. The ECM commands it as part of active regeneration. How urgent it is depends on the FMI after SPN 3482 - pick it below. Check first: command the shutoff valve in the service tool and listen for the click.

FaultActiveSPN 3482FMI --J1939 engine ECU
SPN 3482
Aftertreatment 1 fuel shutoff valve
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 3482 - pick it below.

What should I check first?

Command the shutoff valve in the service tool and listen for the click

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 3482?

You'll notice: The aftertreatment fuel shutoff valve is not working, so fuel to the hydrocarbon doser cannot be controlled.

Find the number shown after SPN 3482 on your display.

  • 2SPN 3482 FMI 2: Data is erratic, intermittent or incorrectErratic or implausibleCummins ISX15, PACCAR MX-13
  • 3SPN 3482 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
  • 4SPN 3482 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
  • 5SPN 3482 FMI 5: Current is below normal, or the circuit is openOpen circuitDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 3 more
  • 7SPN 3482 FMI 7: The mechanical part is not responding or is out of adjustmentPart or controllerCummins ISX15, Mack MP8, Mack MP7, PACCAR MX-13 and 1 more
  • 16SPN 3482 FMI 16: Value is above the normal range, moderately severe levelReal conditionCummins ISX15

Checks

0 of 5 done

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

How urgent SPN 3482 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Valve circuit open or shorted: broken wire, corroded plug or a chafed lead near the doser shield
  • Valve stuck open or closed from varnish or dirt in the fuel
  • Fuel supply to the valve restricted or leaking
  • ECM valve driver fault, which is rare and comes only after the wiring is cleared

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 3482 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.