J1939 · Aftertreatment - DPF
SPN 3471 Fault Code
Aftertreatment hydrocarbon dosing valve
What does SPN 3471 mean?
Valve that sprays diesel into the exhaust upstream of the DOC so the aftertreatment can heat up for regeneration. How urgent it is depends on the FMI after SPN 3471 - pick it below. Check first: measure the doser coil resistance at its connector and compare it with the manual range.
- SPN 3471
- Aftertreatment hydrocarbon dosing valve
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 3471 - pick it below.
What should I check first?
Measure the doser coil resistance at its connector and compare it with the manual range
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 3471?
You'll notice: Regeneration cannot start, so the DPF loads with soot, the lamp comes on, and a derate can follow.
Find the number shown after SPN 3471 on your display.
- 1SPN 3471 FMI 1: Aftertreatment hydrocarbon dosing valve is below the normal range, most severe levelReal conditionDetroit DD15
- 3SPN 3471 FMI 3: Aftertreatment hydrocarbon dosing valve signal voltage is above normal, or the circuit is shorted to a high sourceShorted highDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 3 more
- 4SPN 3471 FMI 4: Aftertreatment hydrocarbon dosing valve signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 3 more
- 5SPN 3471 FMI 5: Current in the Aftertreatment hydrocarbon dosing valve circuit is below normal, or the circuit is openOpen circuitDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5 and 3 more
- 7SPN 3471 FMI 7: The Aftertreatment hydrocarbon dosing valve is not responding or is out of adjustmentPart or controllerMack MP8, Mack MP7, Volvo D13
- 12SPN 3471 FMI 12: Failure inside the device or component that handles the Aftertreatment hydrocarbon dosing valvePart or controllerMack MP8, Mack MP7, Volvo D13
- 13SPN 3471 FMI 13: The Aftertreatment hydrocarbon dosing valve value is out of calibrationPart or controllerDetroit DD13 Gen 5, Detroit DD15 Gen 5
- 14SPN 3471 FMI 14: Special-instruction fault for the Aftertreatment hydrocarbon dosing valve; the maker lists a dedicated procedure for itOtherDetroit DD13 Gen 5, Detroit DD15 Gen 5, Mack MP8, Mack MP7 and 1 more
Checks
0 of 5 done
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
How urgent SPN 3471 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Doser nozzle blocked with soot
- Valve stuck closed or open
- Doser coil open or shorted
- Low fuel pressure to the doser
Other Aftertreatment - DPF codes
Source
Detroit Diesel DD15 2014-2016 fault codes list (Diesel Laptops)
This list names SPN 3471 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Detroit DD13, Detroit DD15, Mack MP7, Mack MP8, Volvo D13; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
