EF Logo

J1939 · Aftertreatment - DPF

SPN 5443 Fault Code

DPF hydrocarbon absorption

What does SPN 5443 mean?

The controller's running estimate of unburnt fuel soaked up by the DOC and DPF while it doses fuel for regeneration. How urgent it is depends on the FMI after SPN 5443 - pick it below. Check first: run the doser test in the service tool and compare commanded and actual dose; a dose with no command shows a leaking doser.

FaultActiveSPN 5443FMI --J1939 engine ECU
SPN 5443
DPF hydrocarbon absorption
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 5443 - pick it below.

What should I check first?

Run the doser test in the service tool and compare commanded and actual dose; a dose with no command shows a leaking doser

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 5443?

You'll notice: Fuel is collecting in the DPF, so regeneration is held back and the system warns of a possible hot burn if the build-up is not cleared.

Find the number shown after SPN 5443 on your display.

  • 0SPN 5443 FMI 0: DPF hydrocarbon absorption is above the normal range, most severe levelReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
  • 2SPN 5443 FMI 2: DPF hydrocarbon absorption data is erratic, intermittent or incorrectErratic or implausibleMack MP8, Mack MP7, Volvo D13
  • 7SPN 5443 FMI 7: The DPF hydrocarbon absorption is not responding or is out of adjustmentPart or controllerMack MP8, Mack MP7, Volvo D13
  • 8SPN 5443 FMI 8: DPF hydrocarbon absorption shows an abnormal frequency, pulse width or periodErratic or implausibleMack MP8, Mack MP7, Volvo D13
  • 10SPN 5443 FMI 10: DPF hydrocarbon absorption is changing at an abnormal rateErratic or implausibleMack MP8, Mack MP7, Volvo D13
  • 13SPN 5443 FMI 13: The DPF hydrocarbon absorption value is out of calibrationPart or controllerMack MP8, Mack MP7, Volvo D13
  • 15SPN 5443 FMI 15: DPF hydrocarbon absorption is above the normal range, least severe levelReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5
  • 16SPN 5443 FMI 16: DPF hydrocarbon absorption is above the normal range, moderately severe levelReal conditionDetroit DD15, Detroit DD13, Detroit DD13 Gen 5, Detroit DD15 Gen 5

Checks

0 of 5 done

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

How urgent SPN 5443 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Hydrocarbon doser leaking or sticking open
  • Repeated short regeneration attempts that never reach burn temperature
  • Fuel pressure to the doser wrong
  • Exhaust temperature sensors reading low so the controller doses too much

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list names SPN 5443 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Detroit DD13, Detroit DD15, Mack MP7, Mack MP8, Volvo D13; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.