EF Logo

J1939 · Turbo

SPN 1172 Fault Code

Engine turbocharger 1 compressor intake temperature

What does SPN 1172 mean?

Air temperature at the turbo compressor inlet, read by a sensor before the compressor. The ECM uses it for boost and EGR calculations. How urgent it is depends on the FMI after SPN 1172 - pick it below. Check first: compare the inlet reading with ambient temperature on a cold-soaked engine; they should be close.

FaultActiveSPN 1172FMI --J1939 engine ECU
SPN 1172
Engine turbocharger 1 compressor intake temperature
FMI ?
How it failed - the number after the SPN

Can I keep running with it?

Depends on the FMI

How urgent it is depends on the FMI after SPN 1172 - pick it below.

What should I check first?

Compare the inlet reading with ambient temperature on a cold-soaked engine; they should be close

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Which FMI shows after SPN 1172?

You'll notice: The turbo inlet temperature is misread, so boost control and charge air corrections are a little off and the check-engine lamp comes on.

Find the number shown after SPN 1172 on your display. 2 of them have their own page with causes and checks.

Checks

0 of 5 done

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

How urgent SPN 1172 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Causes

  • Reads cold: an open circuit or a short to supply in the compressor inlet temperature sensor wiring, which the ECM reads as an extremely low temperature
  • Reads hot: signal wire shorted to ground or the compressor inlet temperature sensor element shorted, which the ECM reads as an extremely high temperature
  • Real condition: air inlet pipe restricted or leaking, so the air temperature at the sensor is wrong
  • Real condition: sensor reading heat soaked from the turbo
1 more cause
  • Sensor: poor connector contact at the inlet pipe, which sees vibration from the turbo

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list names SPN 1172 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.