J1939 · Lubrication
SPN 100 FMI 4
Oil pressure sensor voltage low
What does SPN 100 FMI 4 mean?
The oil pressure sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the oil pressure sensor in the service tool; a value pinned at the bottom of its range with a plausible real value points to a ground fault or no supply.
- SPN 100
- Engine oil pressure
- FMI 4
- Voltage below normal or shorted low
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Key on, engine off: read the oil pressure sensor in the service tool; a value pinned at the bottom of its range with a plausible real value points to a ground fault or no supply
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Signal wire shorted to ground between the oil pressure sensor plug and the ECM, or an open signal wire that the ECM pulls down
- No 5 V reference at the oil pressure sensor, from an open reference wire or another sensor on the same supply pulling it down
- Real loss of oil pressure that the sensor is reading correctly, so confirm it with a gauge before blaming the circuit
- Signal wire rubbed through against the block or the oil filter head bracket
1 more causeFewer causes
- Connector flooded with oil or coolant after a leak above it
How it failed
You'll notice: The oil pressure gauge reads zero, sticks at the top or flickers and the warning lamp may come on.
Shorted lowRead from FMI 4: voltage below normal or shorted low
The signal sits at or near zero volts - less than a working sensor can send.
- Meter test
- Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
- Good result
- Open circuit (OL) to ground. A low reading means chafed insulation touching metal.
When to stop
Low oil pressure can wreck bearings in minutes. Stop the engine and check the level before restarting; if the level is right, do not run it again until the pressure is checked with a gauge.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 100 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 100 with FMI 4. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
