EF Logo

Cummins · Aftertreatment - SPN 3226 FMI 9

Cummins Fault Code 2771

Aftertreatment outlet NOx sensor - abnormal update rate

What does Cummins code 2771 mean?

The ECM does not get the outlet NOx sensor messages at the expected rate over the CAN link. This means the NOx sensor is dropping off the bus, or its supply is unreliable. Urgency: check soon - the machine may derate or limit a function. Check first: read the NOx sensor values in INSITE and see whether the outlet reading appears and updates.

FaultCheck2771Cummins · Aftertreatment - SPN 3226 FMI 9

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Read the NOx sensor values in INSITE and see whether the outlet reading appears and updates

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect INSITE or another J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Outlet NOx sensor connector corroded or loose in the exhaust area
  • Outlet NOx sensor failed internally and dropping messages
  • NOx sensor supply voltage low because of a poor connection or fuse
  • CAN wiring to the NOx sensor chafed or open

How it failed

You'll notice: An amber warning lamp or SCR message; if it stays, power can be reduced because the emissions system cannot be verified.

Lost messageRead from how the source describes the code

A module stopped hearing another on the data link, or the data came late or garbled.

Module AModule BCAN HCAN L120 Ω120 Ω
Typical J1939 link: two modules, CAN high and low, a 120 Ω terminator at each end.
Meter test
Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
Good result
About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Same part, other failures: Intake and outlet NOx sensors

Show the other 17 codes
All 26 Intake and outlet NOx sensors codes on one page

Source

Cummins ISX15 (2013-2018) Fault Codes List (Diesel Repair)

This source lists 2771 and its meaning. The guidance on this page is general, not taken from it.

The source covers: Cummins ISX15/X15/ISB6.7/B6.7/L9 engines (J1939 SPN 3226, FMI 9); same code list used in trucks, buses and machines with these engines.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.